This website requires cookies to provide all of its features. By using our website, you agree to our use of cookies - Learn more - Hide this message
Details

Components made of the 3D printing material iglidur I180-PF are universally applicable for all types of wear-resistant parts, such as plain bearings, gears and drive nuts, since this material has also been specifically developed for moving applications. The higher wear resistance as well as a higher temperature resistance (80°C long-term) enlarge the field of application, especially for more dynamic applications with higher surface speeds. The filament can be easily processed on enclosed 3D printers and is slightly more demanding than an ABS filament.

  • Versatile use: good combination of high wear resistance, strength and temperature resistance
  • Good processing ability with an enclosed printer and igus adhesive film

When to use it?

  • When an increased permanent  application temperature of up to 80°C is required.
  • For highly dynamic plain bearing applications

When not to use it?

  • If the application temperature is higher than 80°C in the long-term, or even higher wear resistance is required
  • If I need a filament that is very easy to process or if I only have an open 3D printer
Specification
Dimensions: 

filament diameter: 1.75 mm / 2.85 mm

Outer diameter spool: 205 mm

Inner diameter spool: 55 mm

Spool width: 55 mm

General properties:

Colour: white

Material suitable for: Beginner

Max. moisture absorption (at 23 °C/73 °F, 50% r.h.): 0.3 Wt.-%, test method DIN 53495

Max. water absorption: 0.9 Wt.-%

Net weight: 250 g / 750 g

Coefficient of sliding friction, dynamic, against Cf53 steel: 0.24

Coefficient of sliding friction, dynamic, against 304 stainless steel: 0.17

pv value, max. (dry): 0.23 MPa ⋅ m/s

Flexural strength: 46 / 33 MPa

Physical and thermal properties:

Max. long-term application temperature: 80 °C

Max. short-term application temperature: 90 °C

Lower application temperature: -40 °C

Thermal expansion coefficient (at 23°C/73°F): 9 K-1 ⋅ 10-5, test method DIN 53752

Heat conductivity: 0.23 W/(m ⋅ K), test method ASTM C 177

Pressure load: 59 MPa

Max. recommended surface pressure (at +20 °C/68 °F): 30 MPa

Requirements:

Mould-free according to DIN EN ISA 846 Procedure A: No

Processing instructions:

Nozzle temperature (min.): 250 °C

Nozzle temperature (max.): 260 °C

Bed temperature (min.): 90 °C

Bed temperature (max.): 110 °C

Recommended adhesion: igus® adhesive film

Construction space: Closed installation space necessary

Component cooling: A component cooling is not necessary, with cooling switched on it is also possible to print

 

Support

Do you have any questions and / or comments?

Reply within one working day

Contact information


Message


This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Reviews

IGUS IGLIDUR I180

Components made of the 3D printing material iglidur I180-PF are universally applicable for all types of wear-resistant parts, such as plain bearings, gears and drive nuts, since this material has also been specifically developed for moving applications. The higher wear resistance as well as a higher temperature resistance (80°C long-term) enlarge the field of application, especially for more dynamic applications with higher surface speeds. The filament can be easily processed on enclosed 3D printers and is slightly more demanding than an ABS filament.

Colors
from €76.16
In stock
SKU
IGU010002
In Stock: make selection

Check full stock

Back to top