At colorFabb we have a well equipped 3d printing studio with a lot of popular 3d printers. We know our materials will give you excellent results and to help you get these results here are tips and tricks for using colorFabb 3d printing filament.

TIP! Depending on your set-up, 3d printer and slice software, you might see that copperFill needs a bit more flow compared to your normal PLA settings. Most plastics will show die swell when coming out of the nozzle tip, this is counteracted with specific slicer settings. Since copperFill doesn’t show a die swell such as PLA you might need to increase flow rate a bit, 4-8% was perfect for our UM2. UM original did not need any adjustments.

TIP! Sanding and polishing your parts will make the copper particles shine. Start sanding with grit 120-180 and make sure all the printed lines vanish. You’ll notice that because copperFill is easy to sand down, careful you won’t loose too much detail. Then start working your way up by following with grit 240-320 and finishing off with grit 600 - or higher. Finally we used a clean soft cloth and some copper polish to really get all of the shine out of the copper particles.

TDS

Technical Data Sheets

SDS

Safety Data sheets