This website requires cookies to provide all of its features. By using our website, you agree to our use of cookies - Learn more - Hide this message
Details

nGen-CF10

Our great all-round 3D printing filament just got better with the addition of a chopped carbon fiber blend. nGen-CF10 retains good toughness and adds a matte carbon fiber look to your 3D printed parts. This filament is very easy to print and requires little to no adjustments compared to printing regular nGen.

Pros

Easy to print carbon fiber filled material

Matte surface finish look

High temperature resistance 85C

Warp free printing.

 

Cons

Needs hardened steel nozzle to minimize wear

Drying can be needed after sometime exposed to the environment

 

Difference between XT-CF20 and nGen-CF10

The main difference between XT-CF20 and nGen-CF10 is the base polymer XT and nGen. This gives a slight advantage to nGen-CF10 interms of temperature resistance, about 5-10C. The lower carbon fiber content also makes nGen-CF10 easier to work with an less susceptible to material accumulating around the nozzle during printing.

Drying of nGen-CF10 is recommended when users observe excessive stringing / oozing on travelmoves. The melt of the material will become easier to control when dried properly at 70C for 4-9 hours depending on the time it has spend exposed to the environment.

 

Specification
Material: 
colorFabb nGen-CF10
Diameter Tolerance:
± 0.05 mm
Density:
1.20 g/cm3

Glass Transition Temperature:
85C

Printing Advice

At colorFabb we have a well equipped 3d printing studio with a lot of popular 3d printers. We know our materials will give you excellent results and to help you get these results here are tips and trick for using colorFabb 3d printing filament.

Adviced 3D printing temperature 
220-240C
Adviced 3d print speed
40 - 70 mm/s

Advised Heated bed 
75-85C

Cooling fan
-

 

Downloads
Support

Do you have any questions and / or comments?

Reply within one working day

Reviews

nGen-CF10

Our great all-round 3D printing filament just got better with the addition of a chopped carbon fiber blend. nGen-CF10 retains good toughness and adds the matte carbon fiber high quality surface finish look to your 3D printed parts. This filament is very easy to print and requires little to no adjustments compared to printing regular nGen.


Please note: A special point of attention is the abrasive nature of the carbon fibers. In general these fibers will accelerate the nozzle-wear of brass nozzles, much faster than unfilled filaments. We recommend to use from stainless steel nozzles or nozzles made with hardened copper alloys.

  • Carbon matte surface finish
  • Easy to print 
  • Temp. resistance 85C
from €49.95
In stock
SKU
020059
In Stock: make selection

Check full stock

Back to top